Achieve real cork-like aesthetics with our EasyCork filament. Made with 30% cork particles, it's easy to print and perfect for creating objects with a cork-like feel, look and smell. Available while stock lasts.

Our EasyCork filament is the perfect solution for achieving real cork-like aesthetics in your 3D-printed objects. Made with 30% cork particles, it's easy to print and perfect for creating objects with a cork-like feel, look and smell. The filament is based on our EasyFil PLA compound and the 30% gravimetrical filling with cork fibers makes the filament absolutely warp-free. EasyCork has great thermal stability and filament-flowing behavior, making it perfect for first- and inter-layer adhesion. It can also be printed at high printing speeds. Unique features of this filament include its lightweight and impact resistance, as well as its high cork filling and real cork feel, look, and smell. Please note that EasyCork filament will be discontinued due to the stop of the supply of raw materials needed for the EasyCork compound. EasyCork filament will only be available as long as stock lasts. The filament is biodegradable and available in 1.75mm and 2.85mm diameters, and in 500-gram, 250-gram, and 2300-gram weights.

Unique features

• High cork filling

• Real cork feel, look, and smell

• Very easy to print

• Warp-free printing

• Great thermal stability and filament-flowing behavior

• Perfect first- and inter-layer adhesion

• Can be printed at high printing speeds

• Lightweight and impact resistant

• Biodegradable

Download Technical Data Sheet Here

General printing guidelines

Above displayed settings are meant as guidance to find your optimal print settings. These ranges in settings should work for most printers, but please do feel free to experiment outside these ranges if you think it is suitable for your printer. There is a lot of different type of printers, hot-ends and printer offset so it is extremely difficult to give an overall one-size-fits-all setting.

Filament length

Nozzle cleaning

When printing with filled/composite filaments it is recommended to clean your nozzle immediately after printing by feeding 15-20cm PLA filament through your nozzle. This will make sure that any potential fillers are flown out of your nozzle. It is even better to use glow-in-the-dark PLA as the extremely hard phosphorous particles are much more likely to scrape out residual waste from your nozzle.

Product export information

Compliance

This filament is compliant with the below-listed directives and regulations.

• RoHS directive 2011/65/EC

• REACH directive 1907/2006/EC

This declaration of conformity to directives and regulations is prepared according to our present standard of knowledge and may be amended if new cognitions are available and applies only to the above-described products.